Laminate insert change out

 
Post new topic   Reply to topic    Bushtracker Forum Forum Index -> GENERAL DISCUSSION
View previous topic :: View next topic  
Author Message
Gamba1973



Joined: 06 Nov 2017
Posts: 16
Location: Ridgewood
State:: WA
Current Bushtracker owner:: No
PostPosted: Sat Jan 19, 2019 9:41 am    Post subject: Laminate insert change out Reply with quote

Hi all.
For those considering changing upholstery/colours is it possible to changs the table top and work surface inserts. Ive read that upholstrey can be done locally as opposed to factory, does the same go for the inserts.
Thanks in advance.
_________________
2014 LC200 TTD.
Researching for possible future BT purchase.
Back to top
View user's profile Send private message
Roachie



Joined: 31 Dec 2015
Posts: 172
Location: Kadina
State:: SA
Current Bushtracker owner:: Yes
PostPosted: Mon Jan 21, 2019 11:13 am    Post subject: Reply with quote

Any competent kitchen fabricator should be able to make you some bench tops and table covering etc.

I've been considering doing ours as there is a VERY slight burn mark on the laminate beside the stove where the "maid" had used a pan that was too wide and the heat from the flame has singed the creamy coloured laminate....about 8mm round section. Hardly worth worrying about really.
_________________
2013 Bushtracker being tugged along by 2012 Chev Silverado. Bee-ute-tee-full!!!
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    Bushtracker Forum Forum Index -> GENERAL DISCUSSION All times are GMT + 10 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum